MXRR TITANIUM GRADE 5 LAMBDA PROBE BOLT PLUG
This is an Ultra light
bolt kit for Lambda Probes: only 27.6 gr
A must for all professional tuners.
The kit includes:
-
M18 PLUG (BOSH type)
-
SPACER 10.80 mm
-
COPPER WASHER
The spacer has a fillet of 1.30 mm to allow proper
installation in the pipe:
MANUFACTURING FEATURES:
-
Billets
Aerospace grade 5 titanium
-
Micro
Polished
INSTALLATION NOTES:
-
The lambda sensor should be installed at point which permits the measurement of a representative
exhaust-gas mixture, which does not exceed the maximum permissible temperature.
-
Install at a point where the gas is as hot as
possible – normally is approx. 25 cm from the
exhaust port.
-
Observe the maximum permissible temperature.
-
As far as possible install the sensor
vertically (wire upwards).
-
The sensor is not to be
fitted near to the exhaust pipe outlet, so that the influence of the
outside air can be ruled out.
-
The exhaust-gas passage opposite the sensor
must be free of leaks in order to avoid the effects of leak air.
-
Protect the sensor against condensation water.
-
The sensor is not to be painted, nor is wax to
be applied or any other forms of treatment. Use only the recommended grease for
lubricating the thread.